Microphone
From DDL Wiki
| header 1 | header 2 | header 3 |
|---|---|---|
| Row header 1 | cell 1,1 | cell 1,2 |
| Row header 2 | cell 2,1 | cell 2,2 |
| Part Number | Photo | Part name | weight (g) | notes |
|---|---|---|---|---|
| 1 | Ring | 2 | attaches to mic end of boom shaft | |
| 2 | Boom shaft | 493 | ||
| 3 | Counterwieght | |||
| 4 | Mic holder | 10 | ||
| 5 | Bolt A | 3 | holds mic holder to #7 | |
| 6 | Bolt B | 2 | #6 goes into #5 | |
| 7 | (part that screws onto boom) | 12 | ||
| 8 | (part that screws onto mic stand) | 71 | ||
| 9 | Rubber pad (2X) | 8 | goes inside #8 to hold #11 in place | |
| 10 | Bolt C | 16 | holds #8, #9, and #10 together | |
| 11 | Boom holder | 65 | has a long hole in which the boom is inserted. Attaches to mic stand
via #8 | |
| 12 | Washer | #10 goes throught this washer | ||
| 13 | Ring | 2 | Identical to #1 | |
| 14 | Handle | Has a threaded hole in which the end of #10 is inserted | ||
| 15 | Thumbscrew | 3 | Holds boom in place. Goeas through hole in #11. Has plastic nub so as
not to scratch the boom | |
| 16 | Wire clip | 2 | Attaches to mic stand, used to hold wire in place |
| Part Number | Photo | Part name | Weight (g) | Notes |
|---|---|---|---|---|
| M1 | cell 1,1 | cell 1,2 | ||
| M2 | cell 2,1 | cell 2,2 | ||
| M3 | cell 2,1 | cell 2,2 | ||
| M4 | cell 2,1 | cell 2,2 | ||
| M5 | cell 2,1 | cell 2,2 | ||
| M6 | cell 2,1 | cell 2,2 | ||
| M7 | cell 2,1 | cell 2,2 | ||
| M8 | cell 2,1 | cell 2,2 | ||
| M9 | cell 2,1 | cell 2,2 | ||
| M10
|
