Windshield wipers
From DDL Wiki
(Difference between revisions)
| Line 1: | Line 1: | ||
{| class="wikitable" border="1" | {| class="wikitable" border="1" | ||
|- | |- | ||
| - | ! colspan="3" | | + | ! |Part # !!colspan="3"| Part Name !! Quantity !! Weight (grams) !! Function !! Manufacturing Process !! Picture |
|- | |- | ||
! 1 | ! 1 | ||
Revision as of 13:48, 23 September 2007
| Part # | Part Name | Quantity | Weight (grams) | Function | Manufacturing Process | Picture | ||
|---|---|---|---|---|---|---|---|---|
| 1 | Motor Connection Nut | 1 | 6 | Holds the entire wiper assembly to the motor | Cast | 
| ||
| 2 | Motor Connection Link (1L) | 1 | 62 | Link connecting the spinning motor to Link 1 | Cast, with the knob pressed into it | 
| ||
| 3 | Link 1 (LN3) | 1 | 158 | Cast, with the knobs pressed into it | 
| |||
| 4 | Rubber Connections | 2 | Unable to detach | Caps on Link 1 that are used to attach to the metal knobs in the connection links | Injection molded and pressed onto the link | 
| ||
| WIPER CONNECTION SUBASSEMBLY 1 | 
| |||||||
| 5 | Rubber cap | 1 | 0 | Rubber cap that goes over the wiper connection point in the subassembly | Injection molded, loose fit | 
| ||
| 6 | Hex Screws | 3 | 7 (#7+#8) | Screw to bolt wiper connection subassembly into car | Cast | 
| ||
| 7 | Washers | 3 | 7 (#7+#8) | Washers to go with hex screws | Cast | 
| ||
| 8 | Rubber thermal mount | 1 | 31 | Rubber around subassembly to allow for mounting | Injection Molded | 
| ||
| RIGID SUBASSEMBLY | All pieces in this subassembly are still attached together and therefore do not have individual pictures. We determined the components by observations | 
| ||||||
| 9 | 7L Link | 1 | Connection to N2 Link 2, which causes the wipers to move | Cast, with the metal pin pressed in | ||||
| 10 | Pin | 1 | Pin that acts as the connection point to N2 Link 2 | Cast, pressed into 7L Link | ||||
| 11 | Press Fit Ring | 1 | Ring around the cylindrical shaft | Molded, press fit onto shaft | ||||
| 12 | Washer | 1 | Washer around shaft | Cast | ||||
| 13 | Cylindrical Rings | 2 | Two metal rings around the shaft of the assembly that allows for rotations, act like bearings | Cast, loose fit atop grease to allow for rotation | ||||
| 14 | Cap | 1 | Cap on top of shaft that holds the shaft pieces together | Cast, press fit together with shaft | ||||
| 15 | N2 Link 2 | 1 | 31 | Rubber around subassembly to allow for mounting | Injection Molded |
| ||
