Automatic apple peeler
From DDL Wiki
(Difference between revisions)
(→Design Documentation) |
(→Design Documentation) |
||
Line 23: | Line 23: | ||
|- | |- | ||
! 5 | ! 5 | ||
- | | threaded rod, length 45cm, diameter 0.9cm || | + | | threaded rod, length 45cm, diameter 0.9cm || 1 || acquired from mechE shop || Spinning threads move forward the rolling frame || $30 || [[Image:threaded rod.jpg|150px|]] |
|- | |- | ||
! 6 | ! 6 | ||
- | | motor fixture || | + | | motor fixture || 2 || milling machine/steel || To fix motors to the base/rolling frame || $8 || [[Image:fixture.jpg|150px|]] |
|- | |- | ||
! 7 | ! 7 | ||
Line 32: | Line 32: | ||
|- | |- | ||
! 8 | ! 8 | ||
- | | apple slicer || 1 || purchased from Chefmate|| To slice apple into 8 pieces || $5 || [[Image:slicer.jpg|150px|]] | + | | apple slicer 18cm x 11cm x 3.5cm || 1 || purchased from Chefmate|| To slice apple into 8 pieces || $5 || [[Image:slicer.jpg|150px|]] |
|- | |- | ||
! 9 | ! 9 | ||
Line 44: | Line 44: | ||
|- | |- | ||
! 12 | ! 12 | ||
- | | 8 inch corner brace || | + | | 8 inch corner brace || 2 || purchased from LG sourcing Inc. || To reinforce the slicer || $8 || [[Image:corner brace.jpg|150px|]] |
|- | |- | ||
! 13 | ! 13 | ||
- | | washer, diameter 1.5cm, hole width 0.8cm || | + | | washer, diameter 1.5cm, hole width 0.8cm || 4 ||purchased || To fix slicer || $1 || [[Image:washer.jpg|150px|]] |
|- | |- | ||
! 14 | ! 14 | ||
- | | bolt, length 3cm, diameter 0.5cm || | + | | bolt, length 3cm, diameter 0.5cm || 2 || purchased || To fix slicer || $1 || [[Image:bolt1.jpg|150px|]] |
|- | |- | ||
! 15 | ! 15 | ||
- | | butterfly nut, hole width 0.5cm || 1 || purchased || To fix slicer || $1 || [[Image:nut1.jpg|150px|]] | + | | butterfly nut, hole width 0.5cm || 2 || purchased || To fix slicer || $1 || [[Image:nut1.jpg|150px|]] |
+ | |- | ||
+ | ! 16 | ||
+ | | battery|| 1 || purchased || To fix slicer || $1 || [[Image:nut1.jpg|150px|]] | ||
|} | |} |
Revision as of 22:19, 7 December 2009
Design Documentation
Following table is the list of materials used for the final prototype.
The case, small screws, washer, and bolts are not shown in the CAD model, but they are included in the list.