Automatic apple peeler
From DDL Wiki
(Difference between revisions)
(→Design Documentation) |
(→Design Documentation) |
||
Line 35: | Line 35: | ||
|- | |- | ||
! 9 | ! 9 | ||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
- | |||
| butterfly nut, hole width 0.5cm || 1 || purchased || To fix slicer || $1 || [[Image:nut1.jpg|150px|]] | | butterfly nut, hole width 0.5cm || 1 || purchased || To fix slicer || $1 || [[Image:nut1.jpg|150px|]] | ||
|- | |- | ||
- | ! | + | ! 10 |
| peeler handle || 1 || taken from original peeler<br />badbath&beyond Inc || To connect all the parts needed for peeling || $5 || [[Image:peeler handle.jpg|150px|]] | | peeler handle || 1 || taken from original peeler<br />badbath&beyond Inc || To connect all the parts needed for peeling || $5 || [[Image:peeler handle.jpg|150px|]] | ||
|- | |- | ||
- | ! | + | ! 11 |
| peeler blade || 1 || taken from original peeler<br />badbath&beyond Inc || To peel apple skin || $2 || [[Image:blade.jpg|150px|]] | | peeler blade || 1 || taken from original peeler<br />badbath&beyond Inc || To peel apple skin || $2 || [[Image:blade.jpg|150px|]] | ||
|- | |- | ||
- | ! | + | ! 12 |
| tri-fork rod || 1 ||taken from original peeler<br />badbath&beyond Inc || To fix apple in place || $5 || [[Image:trifork.jpg|150px|]] | | tri-fork rod || 1 ||taken from original peeler<br />badbath&beyond Inc || To fix apple in place || $5 || [[Image:trifork.jpg|150px|]] | ||
+ | |- | ||
+ | ! 13 | ||
+ | | 8 inch corner brace || 1 || purchased from LG sourcing Inc. || To reinforce the slicer || $8 || [[Image:corner brace.jpg|150px|]] | ||
+ | |- | ||
+ | ! 14 | ||
+ | | washer, diameter 1.5cm, hole width 0.8cm || 2 ||purchased || To fix slicer || $1 || [[Image:washer.jpg|150px|]] | ||
+ | |- | ||
+ | ! 15 | ||
+ | | bolt, length 3cm, diameter 0.5cm || 1 || purchased || To fix slicer || $1 || [[Image:bolt1.jpg|150px|]] | ||
+ | |||
|} | |} |
Revision as of 22:05, 7 December 2009
Design Documentation
Following table is the list of materials used for the final prototype.
The case, small screws, washer, and bolts are not shown in the CAD model, but they are included in the list.