Storage Lift Sliding Bracket Assembly
From DDL Wiki
(Difference between revisions)
m |
|||
| Line 1: | Line 1: | ||
1.) Locate a spacer(18) between 2 pulley wheels(14) at the sliding bracket(10) hole indicated below. Feed, set and eject the 1.5" rivet pin(13). | 1.) Locate a spacer(18) between 2 pulley wheels(14) at the sliding bracket(10) hole indicated below. Feed, set and eject the 1.5" rivet pin(13). | ||
| - | [[Image:Storag_Lift_Sliding_Bracket_Assembly_01.jpg]] | + | [[Image:Storag_Lift_Sliding_Bracket_Assembly_01.jpg|400px]] |
2.) Place 2 springs(16) at the inside of the lower tab of the sliding bracket(10). Position U-Rod(15) as shown, and slide through the lower tab, springs(16), and upper tab in that order. | 2.) Place 2 springs(16) at the inside of the lower tab of the sliding bracket(10). Position U-Rod(15) as shown, and slide through the lower tab, springs(16), and upper tab in that order. | ||
| - | [[Image:Storag_Lift_Sliding_Bracket_Assembly_02.jpg]] | + | [[Image:Storag_Lift_Sliding_Bracket_Assembly_02.jpg|400px]] |
3.) Press fit 2 U-Rod Pins(17) through the U-Rod(15) holes until they are relatively centered. | 3.) Press fit 2 U-Rod Pins(17) through the U-Rod(15) holes until they are relatively centered. | ||
| - | [[Image:Storag_Lift_Sliding_Bracket_Assembly_03.jpg]] | + | [[Image:Storag_Lift_Sliding_Bracket_Assembly_03.jpg|400px]] |
Revision as of 14:00, 6 May 2007
1.) Locate a spacer(18) between 2 pulley wheels(14) at the sliding bracket(10) hole indicated below. Feed, set and eject the 1.5" rivet pin(13).
2.) Place 2 springs(16) at the inside of the lower tab of the sliding bracket(10). Position U-Rod(15) as shown, and slide through the lower tab, springs(16), and upper tab in that order.
3.) Press fit 2 U-Rod Pins(17) through the U-Rod(15) holes until they are relatively centered.
