From DDL Wiki

Revision as of 11:06, 3 October 2008

Client Comments on Report

We received your report. Your summary suggests that your findings are only (1) that the DFA has no room for improvement, and (2) that disassembly can be improved (but how specifically?). Are these the only significant findings?

Specific comments follow:

• You include significant discussion on general relationships with our suppliers or shop practices such as stocking backup tooling. This is not necessary - suppliers need only meet our specs and would not be subject to product liability if they fulfill their specs. We would like you to focus on your product. The stakeholder needs more specific to the product itself are more critical, and here you seem to be missing some important ones: safety, durability / life, stable, flexible mounting, flexible lighting, does not damage surfaces, etc. Please revise to focus on specifics for this product, and please provide a bullet list of needs for the customer and other significant stakeholders with specific needs.
• Please provide a picture or diagram to support understanding of your system function descriptions.
• In the mechanical analysis, you suggest that there is a "balance between how robust the joints are and the weight they can support". What do you mean?
• You state that your mechanical analysis will "show what the optimal material combination is". Where is this determined?
• Your mechanical analysis does not appear to examine a worst-case scenario. Why do you think the case you tested is most relevant?
• Your component list lacks introductory text. What are the findings?
• We are surprised that so many of the parts, particularly the fasteners, are made from aluminum because it is quite soft. How do you know this is the material. Similarly, why is the spring brass rather than spring steel?
• You mention that "DFM optimizes the manufacturing of a product". We understand DFM to be about optimizing a product for manufacturability, quite a different thing. Please comment.
• What is "DSA"?
• You suggest that the lamp materials have very little value at end of life; however, aluminum does have value and can be sold for recycling.
• The sector you identified for EIOLCA seems to be representative of manufacturing; however you didn't examine the use phase. Is the manufacturing phase significant compared to use?
• You suggest that the best ways to reduce GHGs is redesigning manufacturing or trucking processes, but these are outside of our control. What are the aspects of the product itself that contribute to these (e.g.: more operations required? more space required in trucking?)?
• Your FMEA suggests that the friction knob is the most critical failure mode. What suggestions do you have for improvement?

We look forward to seeing your research results and new ideas in the next report.

Client comments on the Mechanical Analysis

The mechanical analysis provides useful information for the weight support in the lamp linkage. My few comments are:

• If the torque tests were done when the lamp set was in vertical, the joints would be preloaded due to component weights. On the other hand, if the tests were performed when the lamp set was laid horizontally on desktop, then there would be no preload. Therefore please indicate how the tests have been done in the assumptions.
• Since the analysis shows that the arm linkage is able to carry a maximum weight of 1.5 lb, I would like to know the design safety factor based on the current lamp weight. Also, if a user decides to replace the traditional bulb with a compact fluorescent bulb (heavier) for energy saving, how the design factor will be changed?
• I would like to see more conclusion in the end of the analysis. For example, please express how you think about the design - are the joints over-designed?