Search results

From DDL Wiki

For more information about searching DDL Wiki, see Help.

Showing below 8 results starting with #21.

View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500)

Page text matches

• Rapid Fire Needler
  ... . Injection molding will allow a high rate of manufacturing after initial tooling and assembly line setup at a low price and short turnover per unit. The ab ...
  59 KB (9613 words) - 15:44, 7 December 2009
• Motorcycle throttle lock
  ... ing it so smooth, but doing so would be a marginal decrease in cost of the tooling, could cause issues with injection molding, and would make it much less ma ...
  24 KB (3810 words) - 21:55, 6 February 2011
• Mop wringer
  ... antages of mass production can be maximized by limiting the need to change tooling in manufacturing. The injection molded parts, on the other hand, seem no ...
  28 KB (4392 words) - 04:33, 14 February 2012
• Bicycle drivetrain
  ... at assembly is completed by the customer as well as standard bike specific tooling. An experienced user is required to install the drive train assembly corre ...
  26 KB (3926 words) - 19:39, 25 September 2012
• Card shuffler 3
  ... int may be a better solution, even if it costs more upfront for additional tooling and R&D. Finally, the sticker on top of the shuffler, while serving no pra ...
  31 KB (4616 words) - 22:55, 1 February 2014
• Soda gun
  * Plastic parts are injection molded, a low-labor cost but high tooling cost process
  48 KB (7222 words) - 02:44, 4 February 2014
• Bike lock
  * Internal locking mechanism requires special production techniques and tooling * Additional tooling is necessary to line up the individual chain links for pinning and swaging ...
  59 KB (9048 words) - 19:12, 3 February 2014
• Grass trimmer
  *Large investment for injection molding tooling ... ng parts are very similar in dimensions and could both be made with slight tooling alterations
  31 KB (4644 words) - 22:17, 26 February 2014

View (previous 20) (next 20) (20 | 50 | 100 | 250 | 500)